Table of Contents
Advertisement
Trouble?
Unable to access configuration files
- Turn off the camcorder. After a short while, turn it on again. If the
problem persists contact a Canon Service Center.
Unable to complete WPS.
- Turn off the camcorder and access point. After a short while, turn
them on again and try again. If the problem persists, perform
setup using the [Search for Access Points] option (A 206).
Unable to complete WPS. Try the operation again.
- Some access points require pressing and holding the Wi-Fi Pro-
tected Setup (WPS) button. For details, refer to the instruction
manual of your access point.
- Make sure to touch [OK] on the camcorder's screen within
2 minutes of activating the Wi-Fi Protected Setup signal on the
access point, whether by pressing the button or by entering the
PIN code.
Unable to connect
- To avoid interference, use the camcorder at some distance from
devices that emit electromagnetic waves (cordless phones, micro-
wave ovens, etc.).
Unable to connect to the Connect Station.
- An error occurred while trying to pair the camcorder with the
CS100 Connect Station. Check that the connect station is ready
to establish a connection and carefully hold the camcorder close
to the connect point on the connect station again (A 194).
275
Advertisement
Table of Contents
