Table of Contents
Advertisement
Turning the TV on or off
Selecting the input source
Input
TV
SCART
SVIDEO
COMPONENT
VGA
HDMI
USB
Move
Enter
Selecting a channel
Adjusting the volume
Displaying program
information
Basic Operations
To turn the TV on or off:
1
Plug the power cord into an AC power outlet, press POWER
2
Press button again to turn off the TV and put the TV in standby mode.
3
To cut off the power completely, unplug the power cord from the power outlet.
Note: If the TV does not receive a broadcast signal for several minutes, the TV will
automatically turn off and go into standby mode.
Warning: When the TV is in standby mode, power is still flowing into the TV. For the sake of
energy saving and safety issue, please disconnect the power cord to completely cut off the
power.
To select the input source:
1
Press INPUT button.
2
Press 6
or 5
to select the input source, then press ENTER.
You can also select the input source using the following remote control buttons:
! HDMI — Press to switch to HDMI mode.
COMP — Press to switch to COMPONENT mode.
!
VIDEO — Press repeatedly to cycle between the SCART/SVIDEO inputs.
!
VGA — Press to switch to VGA mode.
!
TV — Press to switch to TV mode.
!
USB — Press to switch to USB mode.
!
You can use the following ways to change channels:
Press CH+or CH- to go to the next or previous channel. The skipped channels can
!
not be selected.
Press the number buttons to directly select any channel you want, then wait for the
!
channel to change.
Note: Button presses must be within three seconds of each other.
To go to the previous channel viewed, press
!
To browse among your favorite channels you setup, press FAVORITE button
!
repeatedly.
To adjust the volume:
Press the VOL+ or VOL- to increase or decrease the volume.
!
Press the MUTE button to temporarily turn off the sound. To restore the sound, press
!
the MUTE button again.
To display program information:
You can press DISPLAY button to display current program information such as channel
number, color/sound system, or video input source, etc. To clear the display, press this
button again or wait a few seconds and it disappears automatically.
.
12
to turn on the TV.
Advertisement
Table of Contents
