Bissell 16N5 series User Manual page 5

Toolrequired: Phillipsscrewdriver
1, Slide upper handleinto lower handle by
pushingforward. Inserttwo long screws into
the holes marked with arrows and tighten
bothuntil snug.
2,
3,
4,
Attach hoserack by placingthe rack over
the centerback portionof the vacuum.
Be sure to feed the power cordthrough
the hole inthe centerof the rack.Line up
both screws holes and use the two smaller
screws to attach.Tighten both until snug.
Attach hoseby placingthe tabbed endinto
the lower left openingon cordedside of the
vacuum.Makesure the tab on the hosecuff
andthe hole in the vacuum line up. Place
the working end of the hose into the hole on
the side with the extensionwand guides.
Arrangethe hoseso it laysbetweenthe
vacuum andthe rack.
5,
Storethe TurboBrush on the front of the handle
by aligningthe sloton the bottomwiththe tab
on the handle.Snapinto place.
6. Storethe Combination Brushinthe slotshown.
7. Makesurethe crevicetool is insidethe
extension wand.Storetools on vacuumas
shown.
CAUTION:
Do not plug in your
vacuum cleaner until
you are familiar with
all instructionsand
operating procedures.
2a
2b
www.bissell,com 800,237.7691