Jenn-Air S136-C Use And Care Manual page 41

If oven did not clean properly:
• oven may need longer cleaning time.
• excessive spills were not removed prior to self-cleaning process.
• one or several controls may have been turned from CLEAN to another position
after self-cleaning process started.
If oven door will not unlock:
• oven may not have cooled to safe temperature after self-cleaning process.
• TEMPERATURE knob may have been switched from CLEAN position.
• electric current coming into the oven may be off.
If foods do not broil properly:
• the SELECTOR and/or TEMPERATURE knobs may not be set properly.
• check rack position.
• voltage into house may be low.
If baked food is burned or too brown on top:
• the SELECTOR knob may be in the BROIL position.
• food may be positioned incorrectly in oven.
• oven not preheated properly.
If foods bake unevenly:
• the range may be installed improperly.
• check the oven rack with a level.
• stagger pans; do not allow pans to touch each other or oven wall.
• check instructions for suggested placement of pans on oven rack.
If oven baking results are less than expected:
• the pans being used may not be of the size or material recommended for
best results.
• there may not be sufficient room around sides of the pans for proper air circula-
tion in the oven.
• check instructions for preheating, rack position and oven temperature.
• oven vent may have been blocked or covered.
If baking results differ from previous oven:
• oven thermostat calibration may differ between old and new ovens. Follow
recipe and use and care directions before calling for service since the calibration
on the previous oven may have drifted to a too high or too low setting.
To reset unit circuit breaker(s):
1. Lower the access panel.
2. Push in the circuit breaker button
showing red indicator.
NOTE: If the open circuit breaker can't
be easily determined, press all
circuit breaker buttons.
43