Table of Contents
Advertisement
STEP 2
ADJUST LEVELING LEGS
• Move the dishwasher close to the installation
location and lay it on its back.
Adjust to
Installation
Height
Figure H
• Measure installation height and dishwasher height.
Extend leveling legs out from the dishwasher base,
1/4" less than installation height.
STEP 3
REMOVE TOEKICK
• Remove the 4 toekick screws. Lift off the 2 piece
toekick.
Remove
4 Toekick
Screws
Figure J
Installation Instructions
6
STEP 4
INSTALL POWER CORD
Skip this step if dishwasher will be direct wired. Use
power cord kit WX09X70910 available for purchase from
an authorized GE Appliances dealer. The power cord
and connections must comply with the National Electrical
Code, Section 422 and/or local codes and ordinances.
• Recommended power cord length is 54" min. and
64" max.
A
B
Check That White, Black and
Remove
Green Dishwasher Wires Are Threaded
Junction Box
Cover
Ground
D
Use UL Listed
Wire Nuts
Figure K
• Connect incoming
power cord white (or ribbed)
to dishwasher white, black
(or smooth) to black and ground to dishwasher green
wire. Use UL listed wire nuts of appropriate size.
• Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 5
INSTALL 90° ELBOW
• Wrap 90° elbow with thread seal tape.
• Install a 90° elbow onto the water valve.
90
Elbow
Thread
Seal Tape
Figure L
• Do not over tighten 90° elbow, water valve bracket
could bend or water valve fitting could break.
• Position the end of the elbow to face the rear of the
dishwasher.
Thru Hole in Back
White
Black
C
Remove rubber ring,
Insert power cord
wires thru strain
relief and tighten
Fill
Hose
Water
Valve
Bracket
Advertisement
Table of Contents
