Basic Operations; Turning The Unit On And Selecting A; Source; Turning The Unit Off - Pioneer AVX-7650 Operation Manual

Section
04

Basic Operations

Turning the unit on and
selecting a source
1
1 Source icon
Shows which source has been selected.
% Press AV SOURCE to select a video

source.

Press AV SOURCE repeatedly to switch be-
tween the following sources:
AV-1 (video input 1)AV-2 (video input 2)
AV (video of currently selected source)
Notes
! Equipment which is connected to AV-BUS
input can be selected as AV source. You can
watch video from connected equipment
which is selected as a source by a head unit.
! In the following cases, the sound source will
not change:
 When there is no unit corresponding to the
selected source connected to this unit.
 When AV INPUT1 (video input 1) and/or
AV INPUT2 (video input 2) are not set to
VIDEO (refer to page 12).

Turning the unit off

% Press AV SOURCE and hold until the
unit turns off.
8
En
Opening and closing the
LCD panel
The LCD panel will be opened or closed auto-
matically with the turning of the ignition
switch on or off. You can turn off the automatic
close/open function. (Refer to page 13.)
! Do not close the LCD panel with hands by
force. That cause malfunction.
! The automatic close/open function will op-
erate the display as follows.
 When the ignition switch is turned OFF
while the LCD panel is opened, the LCD
panel will close after six seconds.
 When the ignition switch is turned ON
again (or turned to ACC), the LCD panel
will be opened automatically.
 Removing or attaching the front panel
will automatically close or open the LCD
panel. (Refer to page 11.)
! When the ignition switch is turned OFF
after the LCD panel has been closed, turn-
ing the ignition switch ON again (or turning
it to ACC) will not open the LCD panel. In
this case, press OPEN/CLOSE to open the
LCD panel.
! When closing the LCD panel, check to
make sure that it has closed completely. If
the LCD panel has stopped halfway, leaving
it like this could result in damage.
% Press OPEN/CLOSE to open the LCD
panel.
# To close the LCD panel, press OPEN/CLOSE
again.
Adjusting the LCD panel angle
Important
! If you can hear the LCD panel knocking
against your vehicles console or dashboard,
press ANGLE () to move the LCD panel a lit-
tle forward.