Advertisement
Quick Links
Advertisement
Related Manuals for Rhyas AGM4005
Summary of Contents for Rhyas AGM4005
- Page 1 ANGLE POLISHER AGM4005 Manual ORIGINAL INSTRUCTIONS...
- Page 2 Fig. 1 Fig. 2 Fig. 3...
- Page 3 Fig. 4 Fig. 5 Fig. 6...
- Page 4 ANGLE POLISHER AGM4005 Vibration level The vibration emission level stated in this Thank you for buying this Rhyas product. instruction manual has been measured in All our products are manufactured to the highest accordance with a standardised test given in standards of performance and safety.
- Page 5 Indicates electrical shock hazard. the spindle of the power tool. Accessories with Immediately unplug the plug from the arbour holes that do not match the mounting mains electricity in the case that the hardware of the power tool will run out of cord gets damaged and during balance, vibrate excessively and may cause maintenance.
- Page 6 m) Do not run the power tool while carrying it at the accessory. Corners, sharp edges or your side. Accidental contact with the spinning bouncing have a tendency to snag the rotating accessory could snag your clothing, pulling the accessory and cause loss of control or accessory into your body.
- Page 7 c) When wheel is binding or when interrupting • Before use, let the machine run idle for 30 a cut for any reason, switch off the power seconds. Immediately switch off the machine tool and hold the power tool motionless until in case of abnormal vibrations or occurrence of the wheel comes to a complete stop.
- Page 8 4. Use Replacing cables or plugs Immediately throw away old cables or plugs when they have been replaced by new ones. It is Always follow the safety instructions dangerous to insert the plug of a loose cable in and keep to the applicable regulations. the wall outlet.
- Page 9 5. Service & maintenance Faults Should a fault occur, e.g. after wear of a part, Make sure that the machine is not live please contact the service address on the when carrying out maintenance work on warranty card. In the back of this manual you find the motor.
-
Page 10: Spare Parts List
Spare parts list Position Description Pad holder 409486 Bearing 6202 ZZ 806202 Spindle gear 409480 Bearing 409673 14 - 17 Handle complete 409481 18 - 20 Locking pin assembly 409674 Gearbox 409675 Bearing 6201 ZZ 806201 Rotor 409482 Bearing 608 ZZ 800608 Stator 409483... -
Page 14: General Safety Instructions
General Safety InStrUCtIOnS c. Avoid accidental starting. Ensure the switch is in the off position before plugging in. Carrying power tools with Warning! your finger on the switch or plugging in power tools that Read all instructions. Failure to follow all instruc tions listed have the switch on invites accidents. -
Page 15: Declaration Of Conformity
DeClaratIOn Of COnfOrMIty aGM4005 (en) We declare under our sole responsibility that this product is in conformity with directive 2011/65/EU of the European parliament and of the council of 9 June on the restriction of the use of certain... - Page 16 1406-05...