Chevrolet sonic 2016 Owner's Manual page 158

Three-Way Calling
Three-way calling must be
supported on the cell phone and
enabled by the wireless service
carrier.
1. While on a call, press
2. Say Three-way call.
3. Use the dial or call command
to dial the number of the third
party to be called.
4. Once the call is connected,
g
press
/ to link all callers
together.
Ending a Call
i
Press / to end a call.
Muting a Call
During a call, all sounds from inside
the vehicle can be muted so that the
person on the other end of the call
cannot hear them.
To mute a call, press /
then say Mute Call.
To cancel mute, press
then say Un-mute Call.
Transferring a Call
Audio can be transferred between
the Bluetooth system and the cell
phone.
The cell phone must be paired and
g connected with the Bluetooth
/ .
system before a call can be
transferred. The connection process
can take up to two minutes after the
ignition is turned to ON/RUN.
To Transfer Audio from the
Bluetooth System to a Cell Phone
During a call with the audio in the
vehicle:
1. Press
2. Say Transfer Call.
To Transfer Audio to the Bluetooth
System from a Cell Phone
During a call with the audio on the
cell phone, press
transfers to the vehicle. If the audio
does not transfer to the vehicle, use
g
, and
the audio transfer feature on the cell
phone. See the cell phone
manufacturer's user guide.
g
/ , and
g
/ .
g
/ . The audio
Infotainment System
Voice Pass-Thru
Voice pass-thru allows access to the
voice recognition commands on the
cell phone. See the cell phone
manufacturer's user guide to see if
the cell phone supports this feature.
To access contacts stored in the cell
phone:
g
1. Press / . The system
responds Ready, followed by
a tone.
2. Say Bluetooth. This command
can be skipped.
3. Say Voice. The system
responds OK, accessing
<phone name>.
The cell phone's normal prompt
messages will go through their cycle
according to the phone's operating
instructions.
Dual Tone Multi-Frequency
(DTMF) Tones
The Bluetooth system can send
numbers and the numbers stored as
name tags during a call. You can
use this feature when calling a
157