Glass Assembly; Grilles And Trim; Hood; Air Shutter Setting - Heatilator CNXT70IT Owner's Manual

H. Glass Assembly
WARNING
Handle glass doors with care.
• Inspect the gasket to ensure it is
undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass
door removed, cracked, broken or
scratched.
• Replace glass door assembly as a
complete assembly.
• Removing Glass Assembly
Lift and pull the upper grille towards you to expose the
two (36 in. model) or three (42 in. model) Quick Access
Latches. Open the control access panel to expose the
two (36 in. model) or three (42 in. model) Quick Access
Latches. Rotate the bottom of the screen assembly away
from the appliance and lower out of the top retainers.
Release the top and bottom access latches and rotate
the top of the glass door panel away from the top of the
appliance. Place the glass panel on a surface that will not
scratch the surface of the glass panel.
• Replacing Glass Assembly
Replace the glass panel on the lower access latches
and rotate the upper portion of the glass assembly into
place. Engage the top access latches. Engage the lower
latches in a similar manner. Reinstall the top corners of
the screen assembly in their retainer clips and rotate the
screen assembly to rest on the lower latches. Close the
access panel and reinstall the upper grille.
Latches
(both bottom
and top)
Glass
Assembly
Figure 12.10 Glass Assembly
Heatilator • CNXT Series • 4000-011 Rev N • 11/05
I. Grilles and Trim
• Install optional marble and brass trim surround kits using
the installation instructions included with them.
• Marble, brass, brick, tile or other non-combustible
materials can be used to cover gap between sheet rock
and appliance.
• Do not obstruct or modify the air inlet/outlet grilles.
• Allow space to lower and remove the bottom grille/access
panel.
J. Hood
• Align back edge of hood with attachment clips and press
fi rmly in place.
K. Air Shutter Setting
This appliance has an adjustable air shutter (which controls
the primary air mixture) that can be accessed from under the
valve compartment located under the fi rebox assembly (see
Figure 12.11). If your installation has more than the minimum
vertical vent length, adjustments to the air shutter may be re-
quired to obtain the optimal fl ame appearance. A qualifi ed
installer should adjust this at the time of installation.
It takes 16 full turns of the shutter adjustment handle to move
the air shutter from fully open to fully closed. In the event
of soot accumulation inside your appliance, the air shut-
ter should be opened further. When the shutter adjustment
handle is all the way down, the air shutter is in the closed
position. When the shutter adjustment handle is all the way
up, the air shutter is in the fully open position.
Closed
Figure 12.11 Air Shutter
41