Samsung DV40J3000EW User Manual page 15

6,
7.
8,
Review the Electrical Requirements section, then follow the 3 Wire system connection instructions (Step
7) or 4 Wire system instructions (Step 8) below.
Three Wire system instructions:
A, External ground connector
B. Neutral grounding wire (white or green/yellow)
O, Center silver-colored terminal block screw
D, Neutral wire (white or center wire)
E, 3_,,(1.9 cm) UL-listed strain relief
1, Loosen or remove the center terminal block screw. E
2, Connect the neutral wire (white or center wire) of the power
cord to the center, silver-colored terminal screw of the
terminal block. Tighten screw.
3, Connect the other wires to outer terminal block screws. Tighten screws.
4, Tighten the strain relief screws.
5, Insert the tab of the terminal block cover into your Dryer's rear panel slot.
Secure the cover with a hold-down screw.
WARNING
If converting from a 4-wire electrical system to a 3-wire, you must connect the ground strap
to the terminal block support to ground the dryer frame to the neutral conductor.
Four
A,
B.
O,
D,
E,
F,
[_ e recommend using Ring terminals. If you use Strap terminals, please ensure you install
them perfectly.
Wire System instructions:
External ground connector
Green or bare copper wire of power cord
3_,,(1.9 cm) UL-listed strain relief
Center silver-colored terminal block screw
Neutral Grounding wire (white or green/yellow)
Neutral wire (white or center wire)
1, Remove the External ground connector screw.
2, Connect the ground wire (green or unwrapped) of the
power cord to the external ground connector screw. If you
want to connect B (Green or bare copper wire of power
cord) to the Neutral Post without connecting it to A (cabinet
ground), call a service technician.
3, Loosen or remove the center terminal block screw.
4, Connect the neutral wire (white or center wire) of the power cord and the appliance ground
wire (white or green/yellow stripes) under the central screw of the terminal block.
5, Connect the other wires to the outer terminal block screws. Tighten screws.
6, Tighten the strain relief screws.
7, Insert the tab of the terminal block cover into your Dryer's rear panel slot.
Secure the cover with a hold-down screw.
We recommend using Ring terminals. If you use Strap terminals, please ensure you install
them perfectly.
Engl sh- 15
DV3000] DV40]3000EW USERMANUAL DC68 03170N ENindd 15 2(}14/12/3(} 15:14:43