Reversing The Door; Replacement Of The Interior Lig Ht - Whirlpool WH35S1Q Use & Care Manual

REVERSING THE DOOR

1
2
3
4
7
1. Remove top hinge cover and 3 top hinge screws which are below it. Then
remove top hinge.
2. Remove 1 cabinet plug .
3. Remove the door.
4. Remove right and left leveling legs.
5. Remove the bottom hinge and 3 bottom hinge screws.
6. Install the bottom hinge on the other side of the leveling legs with 3 bottom
hinge screws.
7. Install right and left level ing legs. There are two holes below the refrigerator to
fit the two leveling legs.
8. Install the door .
9. Install the top hinge on the other side with 3 top hinge screws.
10. Install top cover above the top hinge and install 1 cabinet plugs on the other
side.
11. Adjust the leveling legs.
10
1. Top hinge cover
2. Top hinge screw
3. Top hinge
4. Cabinet plug
5. Bottom hinge
6. Bottom hinge screw
7. Leveling leg
Do not tilt the appliance over
45°when revising the door as
possible damage to the sealed
5
system may occur.
6
REPLACEMENT OF INTERIOR LIGHT
Uninstall the cover and replace the light with a screwing light (120V/10W). Refer
to the illustrations and instructions below:
1. Move the lampshade 1.2~2 inches ac cording to arrow point direction.
2. Take out the lamp shade.
3. Rotate and take out the bulb in counterclockwise direction.
4. Replace bulb and reinstall shade.
11