Assembly - Stihl 088 Owner's Manual

• Ease the E-clip off the bell crank
pivot pin.
• Carefully ease the hand guard
(1) and bell crank (2) off the pivot
pins and lift them away together.
- Pull the bell crank out of the
hand guard.
• Remove the E-clip (1).
STIHL 088
• Unhook the spring (2) and take it
away.
• Pull off the cam lever (3).
- Inspect parts. Replace any worn
or damaged parts.
- Clean chain brake seat in crank-
case.
- If the groove of the brake spring
anchor pin is worn, the anchor
pin must be replaced - see 3.3.4.
3.3.2

Assembly

- Lubricate sliding and bearing
points of chain brake with STIHL
multipurpose grease or, prefer-
ably, Molykote grease - see 11.2.
• Push the cam lever (1) onto the
pivot pin.
• Fit the E-clip (2).
• Attach the spring (1) to the pivot
pin (2) and cam lever.
10