Yunca Gas QEWB 2000 Installation Instructions

INSTALLATION INSTRUCTIONS
A. Manufacturer recommends all installations be carried out by competent trades persons.
e.g. (Space Heater Installer) to obtain maximum performance and maintenance free heating.
B. A permit is normally required and we suggest you check with your local building inspectors as by-
laws can vary from area to area. Also notify your Insurance Company that a space heater has been
installed.
C. Hearth-
D. Manufacturers recommend minimum clearances from combustible walls.
COAL RESEARCH tested to NZS 7421-1990
Rear Clearance (with YUNCA flue guard fitted)
Side Clearance (with YUNCA flue guard fitted)
Rear Clearance (with ½ round flue guard fitted)
Side Clearance (with ½ round flue guard fitted)
Corner Clearance (with YUNCA flue guard fitted)
Corner Clearance (with ½ round flue guard fitted)
* ADDITIONAL QEWB 2000 WOOD FIRE HEAT SHIELD REQUIRED
E. FLUE KIT
1. 3.6 m x 150 mm stainless steel flue
2. 1 x weather cap & cowl
3. 2 x 900 mm 250mm galvanised liner
Wood Fire Only Requires:
NOTE: All joints must be sealed with flue sealing compound & screwed or riveted together, including the first
length of flue being screwed to flue spigot.
F. HALF ROUND GUARD KIT
1. 1200mm stainless steel back
G. YUNCA FLUE GUARD KIT (Accessory kits also available)
1. 1 x 1200mm length back guard
3. 1 x 900mm back guard
13-05-15
WOOD BURNER AND MULTIFUEL
TESTED TO NZS 7421-1990
1. Must extend at least 300mm Multi Fuel (200mm Wood) in front of heater Door.
2. Must extend at least 100mm on each side of heater.
3. Spill Ash hearth must be constructed of non-combustible material.
Qewb 2000 Wood Fire Heat Shield and Brackets.
A division of Terry Young Ltd.
Febuary 2003
4. 2 x spider brackets
5. 1 x ceiling tile
6. 1 x secondary shield
2. 900mm stainless steel back
2. 1 x 1200mm perf. front guard
2000
2000 FREESTANDING
Multi-Fuel Wood
220mm *100mm
500mm *200mm
250mm *150mm
500mm *200mm
100mm *40mm
100mm *40mm
QEWB2000 Feb 2003.doc