Table of Contents
Advertisement
other than grinding.
f) Grinding wheels must be stored and handled
with care in accordance with the manufacturer's
instruction.
g) Inspect the grinding wheel before use to ensure
that it is not chipped or cracked. Chips or cracks
can cause the wheels to shatter, resulting in
possible serious injury.
h) Ensure that the wheel is fitted in accordance with
this manual.
i)
Ensure that the grinding wheel is correctly mounted
and tightened before use and run the tool at no-
load speed for 30 seconds in a safe position. Stop
immediately if there is considerable vibration or if
other defects are detected. If this condition occurs,
check the tool to determine the cause.
j)
Do not use separate reducing bushings or adapters
to adapt large hole grinding wheels.
k) Check that the workpiece is properly supported.
l)
Use only grinding wheels approved by RYOBI.
m) Ensure that sparks resulting from use do not
create a hazard, e.g., do not hit people, or ignite
flammable substances.
n) Always use protective safety glasses and ear
protectors.
o) Use other personal protective equipment such as
gloves, apron and helmet when necessary.
p) Never place the tool on the floor or other surfaces
while it is running. Grinding wheels continue to
rotate after the tool is switched off. Never touch
the wheel or place it on the floor or other surfaces
while it is rotating.
q) The flange and clamp nut must have the same
outer diameter.
r) Use the tool only for approved applications. Never
use coolants or water or use the tool as a fixed tool.
s) Grip the tool securely with both hands while
operating.
INTENDED USE
Grinding metals.
Use the tool only for approved applications. Use of the
power tool for operations different from intended could
result in a hazardous situation.
LIVE TOOL INDICATOR
This tool features a live tool indicator which illuminates as
soon as the tool is connected to the supply. This warns the
user that the tool is connected and will operate when the
switch is pressed.
4
MAINTENANCE
WARNING
Do not make any adjustments while the motor is in
motion.
Always disconnect the power cord from the socket
before changing removable or expendable parts,
before lubricating or working on the unit.
■
After use, check the tool to make sure that it is in good
condition.
■
It is recommended that you take this tool to a Ryobi
Authorized Service Center for a thorough cleaning and
lubrication at least once a year.
■
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorized service
center to avoid risk. Contact authorized service center.
WARNING
To ensure safety and reliability, all repairs should be
performed by an authorised service center or other
qualified service organisation.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories
and
packaging
environmental-friendly recycling.
SYMBOLS
Safety Alert
Class II tool, double insulation
Please read the instructions carefully before
starting the product.
Wear ear protection
Wear eye protection
Wear dust mask.
Do not use chipped, cracked or defective
grinding wheel
Safety
should
be
sorted
for
Advertisement
Table of Contents
