BMW R 1200 RT Rider's Manual page 89

To deactivate the motion
sensor (for example if you
are about to transport the
motorcycle on a train and the
swaying movement of the
moving train could trip the
alarm), press button 1 on the
remote control or the radio-
operated key again during the
activation phase.
Turn indicators flash three
times.
Confirmation tone sounds three
times (if programmed).
Motion sensor is deactivated.
Alarm
An alarm can be triggered by
the motion sensor
an attempt to use an unau-
thorised key to switch on the
ignition
disconnection of the DWA anti-
theft alarm from the motor-
cycle's battery (DWA internal
battery in the anti-theft alarm
provides power - alarm tone
only, the turn indicators do not
flash)
All functions are sustained even
if the internal battery of the DWA
anti-theft alarm system is flat; the
only difference is that an alarm
cannot be triggered if the system
is disconnected from the motor-
cycle's battery.
An alarm lasts for approximately
26 seconds. While an alarm is in
progress an alarm tone sounds
and the turn indicators flash. The
type of alarm tone can be set by
an authorised BMW Motorrad
dealer.
You can cancel an alarm at any
time without deactivating the
anti-theft alarm by pressing but-
ton 2 on the remote control or
the radio-operated key.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched on.
The anti-theft alarm telltale light
4
87
z