Electrical Connection; Removal - Bosch SB series Instruction Manual

en Installation and connection

Electrical connection

Connect the appliance to an
■
alternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with
protective earth conductor. See
rating plate for required fusing 9J.
The socket must be near the
■
appliance and freely accessible
following installation.
If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side to
satisfy the relevant safety
instructions.
The connection may be modified
■
by technicians only.
A power cord extension may be
■
purchased from customer service
only.
Use only a residual current operated
■
circuit-breaker which features the
symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
■
damage protection system. Please
note the system will function only
when the power supply
is connected.
50

Removal

Also observe
the sequence of worksteps here.
Disconnect the appliance from the
1.
power supply.
Turn off the tap.
2.
Undo the waste water and drinking
3.
water connection.
Loosen fastening screws for the
4.
furniture parts.
If fitted, remove the base panel.
5.
Pull out the appliance, carefully
6.
pulling the hose behind.