Board; Rm-45 Board - Sony DPP-EX7 Service Manual

2-1-6. RM-45 Board

1. Remove the upper cabinet assembly. (Refer to Section
1-2-1.)
2. Remove the DK-45 board. (Refer to Section 2-1-1.)
3. Remove the paper eject guide assembly. (Refer to
Section 2-3.)
4. Remove the mechanical deck assembly. (Refer to
Section 2-4.)
5. Remove the MD-45 board. (Refer to Section 2-1-3.)
6. Remove the paper feed frame assembly. (Refer to
Section 2-8.)
7. Remove the four hooks, then remove the paper guide
assembly from the paper feed frame assembly.
8. Remove the two hooks of the paper feed frame
assembly in the direction indicated by the arrow A,
then remove the RM-45 board in the direction
indicated by the arrow B.
9. Disconnect one harness from the connector (CN1040)
on the RM-45 board.
Hook
Paper feed frame
assembly
Hook
Harness
CN1040
Hook
RM-45 board
Paper feed frame
assembly
10. Install the RM-45 board in the reverse order of steps 1 to 9.
2-4
B
A
A
RM-45 board
Paper guide
assembly
Hook
Hook
2-1-7. PR-45 Board
1. Remove the upper cabinet assembly. (Refer to Section
1-2-1.)
2. Remove one screw, then remove the spring (PR).
3. Remove the two screws, then disconnect the harness
and remove the PR-45 board.
4. Disconnect one flexible flat cable from the connector
(CN1001) on the PR-45 board.
Harness
BVTP
2.6x6
Flexible flat cable
5. Install the PR-45 board in the reverse order of steps 1
to 4.
Upper cabinet
assembly
CN1001
PR-45 board
Spring (PR)
BVTP
2.6x6
DPP-EX7 V1