SPECIFICATIONS Tuner section General Frequency range Speaker 100 mm cone type (2) FM : 87.5 MHz - 108.0 MHz 60 mm cone type (2) Antenna : Rod antenna Output Headphones jack (stereo mini-jack) AM : 531/530 kHz - 1,602/1,710 kHz Power output 2.5 W + 2.5 W (EIAJ 7 ohms DC) (9/10 kHz/step)
PROTECTION OF EYES FROM LASER BEAM DURING SERVICING This set employs laser. Therefore, be sure to follow carefully the CAUTION instructions below when servicing. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous WARNING! radiation exposure.
CHIP RESISTOR PART CODE Chip Resistor Part Coding Figure Resistor Code Value of resistor Chip resistor Dimensions (mm) Wattage Type Tolerance Symbol Resistor Code Form 1/16W 1005 0.35 1/16W 1608 0.45 1/10W 2125 1.25 0.45 1/8W 3216 0.55 TRANSISTOR ILLUSTRATION E C B B C E E C B...
Page 19
IC DESCRIPTION IC, LC867132V-5P07 Pin No. Pin Name Description O-RWC / CE CD read/write control (TU CE). O-DATA Data output to LC72121M/M62495FP. O-CLK CLK output to LC72121M. Not used. O-CK SFT Clock shift output of the microcomputer. I-HOLD Hold status detection. I-RET Microcomputer reset pin.
Page 20
VSS3 Connected to GND. 43~44 S12~S13 LCD segment output. 45~50 S16~S21 LCD segment output. 51~54 S22~S25 Not used. O-CD LED LED ON/OFF control output for CD functions. O-TU LED LED ON/OFF control output for TU functions. O-TA LED LED ON/OFF control output for TAPE functions. O-ROCK LED LED ON/OFF control output for ROCK.
Page 21
IC, LC78622ED Pin No. Pin Name Description DEFI Defect detection signal (DEF) input. Test input. A pull-down resistor is built in. Must be connected to 0V. External VCO control phase comparator output. VVSS – Internal VCO ground. Must be connected to 0V. ISET PDO output current adjustment resistor connection.
Page 22
Pin No. Pin Name Description LVSS – Left channel one-bit D/A converter ground. Must be connected to 0V. RVSS Right channel one-bit D/A converter ground. (Must be connected to 0V.) RCHO Right channel onr-bit D/A converter output. RVDD Right channel one-bit D/A converter power supply. MUTER Right channel one-bit D/A converter mute output.
Page 23
IC, LA9241ML Pin No. Pin Name Description For the connection of the pickup photodiode. Addition to the FIN1 pin creates an RF FIN2 signal and subtraction from it create an EF signal. FIN1 For the connection of the pickup photodiode. For the connection of the pickup photodiode.
Page 24
Pin No. Pin Name Description The HFL (high frequency level) signal is used to judge whether the main beam is positioned on the pit or on the mirror. SLOF Sled servo off control input. CLV error signal input from the DSP. RFSM RF output.