Page 1
KIWIFOTOS UR-262 Aoraki Camera 2in1 Wireless and Wired Remote Control has 4 models to be compatible with CANON, NIKON, SONY, PENTAX cameras. You can easily use this remote switch on different cameras by changing the connecting cables.
Working Distance Camera Remote Model Maximum Working Range (meter) Maximum Working Range (feet) CANON UR-262C 16.5ft NIKON UR-262N 66ft SONY UR-262S 49.5ft PENTAX UR-262P 26.4ft Specifications Battery type: CR2032 Battery Weight: Approx 21.8g (without battery) Dimension (L × W × D ): 90mm × 34mm × 12mm (3.54" × 1.35" × 0.47") ...
Install the Battery 1.Prize up the battery cover with your finger, then remove the cover from the remote. 2.Insert a CR-2032 battery to the battery compartment with anode facing upwards and press down. Make sure battery is well installed into the battery compartment for use. Do not install batteries in the reverse direction as this could cause the batteries to leak corrosive liquids, generate heat or explode.
Page 4
4.To replace a weak battery, please use your finger to prize up the battery and replace a new one. Use UR-262 with Cord as a Wired Switch Setup Turn off the power of your camera before proceeding to the next step. Plug the end of the connecting cord into the remote as the picture shown left, then plug the other end to the camera remote socket (the appearance of this end for different cameras may varies).
Page 5
Use UR-262 as Infrared Remote UR-262 has built-in infrared code for Canon,Nikon,Pentax,Sony cameras. The function mode dial for this four brands cameras is different. Please refer to following instruction for use. Infrared Function Description For Canon cameras, the function dial acts as the following table shows. Function Dial Function Instant shutter release...
Page 6
For Sony cameras, the function dial acts as the following table shows. Function Dial Function Instant shutter release Delay shutter release Video recording Infrared Function OFF Setting Please refer to your camera manual instruction to turn on Remote Control /Infrared Remote Function, different cameras may varies.
Page 7
Then press the shutter button on UR-262 to enable the function you choose in step 3. When you press the shutter button of the UR-262, the specific function led light will flash. Attention When the remote is not being used for a long time, please keep the function dial at OFF position to ...