JVC DLA-X9000 Instructions Manual page 62

Video image does not appear
Check
Is the correct external input selected?
Is the power of the AV device turned on? Turn on the power of the AV device and play the video.
Is the AV device properly connected?
Are the correct signals being output from
the AV device?
Is the cable in use an HDMI-certified
cable?
Is an intermediate device (AV amplifier,
divider, etc.) in use?
Is an old source device in use?
3D images do not appear
Check
Do you see two images displayed side by
side?
Is an intermediate device (AV amplifier,
divider, etc.) in use?
Is the cable in use an HDMI-certified
cable?
Is the power of the 3D GLASSES turned
on?
Are the 3D GLASSES charged?
Are the 3D GLASSES and 3D
SYNCHRO EMITTER too far away from
each other?
Is the 3D GLASSES and 3D SYNCHRO
EMITTER combination correct?
3D video image looks unnatural
Check
Are there overlapping video images?
62
Select the correct external input terminal.
Connect the AV device properly.
Set the AV device properly.
Use an HDMI-certified high-speed cable. Also, use as
short a cable as possible.
Change the sequence of turning on the source device,
intermediate device and the projector. And after turning on
each device, ensure that the signal output is stable before
turning on the next device.
Change the resolution setting of the source device. For
details on how to change the setting, please refer to the
instruction manual of the source device. Or, try connecting
to the HDMI2 terminal and set "HDMI2 EDID" to "B".
Set "3D Format" to "Side by Side"
Video images in the "Side by Side" format may not be
recognized automatically in the case of 3D video images.
Connect the source device to the projector directly, and
check whether there is any improvement in the condition.
If the condition improves, it is likely that this is not caused
by malfunction of the projector.
Use an HDMI-certified high-speed cable.
Also, use as short a cable as possible.
If you are using the PK-AG2 or PK-AG33D GLASSES, turn
on the power manually.
Check whether the PK-AG1 battery of the 3D GLASSES
has run out, and whether PK-AG2 and PK-AG3 are
charged.
Position them at an appropriate distance.
Check the model name of 3D GLASSES and 3D
SYNCHRO EMITTER, and use the correct combination.
If there are overlapping video images partially, this is due
to the crosstalk phenomenon.
In this case, adjust "Crosstalk Cancel" accordingly.
If there are overlapping video images partially, this is due
to the crosstalk phenomenon.
This phenomenon often occurs when there are drastic
changes in the brightness.
In this case, set Lamp Power to "High"
Action
Action
Action
Refer to
P. 21
P. 18
P. 18
P. 18
P. 18
P. 18
P. 47
Refer to
P. 29
P. 18
P. 18
Check the
instruction
manual of the 3D
GLASSES and
3D SYNCHRO
EMITTER.
P. 9
Refer to
P. 29
P. 43