List Of Accessories - ETC -RW900D User Manual

E. Insert new heating element in PCB board, pay attention to install properly.
F. Install it as the contrary method of remove.
Top shell
Lower shell
Please follow the following steps for the successful replacement of heating
element of soldering station:
A. Cut down power; replace the heating element after it is cool.
B. As following diagram, unscrew the nut
cap and iron tip , then unscrew the fixed holder , desoldering the
heating element .
C. Replace the good condition heating element and install it as the contrary
method of remove.
Quartz tube
PCB
Hot air tube
heating element
, take out the stainless steel
15

List of accessories:

ETC-RW900D
Power cord
Nozzle
Bracket
handle
iron holder
User manual
WARNING:
This tool be placed on its stand when not in use
The instructions for heat guns and hand-held paint strippers shall
include the substance of following:
A fire may result if the appliance is not used with care, therefore
be careful when using the appliance in places where there are
combustible materials:
Do not apply to the same place for a long time;
Do not use in presence of an explosive atmosphere;
Be aware that heat may be conducted to combustible materials
that are out of sight ;
Place the appliance on its stand after use and allow it to cool
down before storage;
Do not leave the appliance unattended when it is switched on;
1 unit
1 strip
1 set
1 set
1 pc
1 set
1 copy
16