KTM 350 EXC-F Owner's Manual page 75

12 BRAKE SYSTEM
–
Stand the vehicle upright.
–
Remove screw cap
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
101382-10
–
Remove cotter pin
–
Clean the brake caliper and brake caliper support.
101383-10
–
Check that leaf spring
caliper support are seated correctly.
100407-10
–
Insert the brake linings, insert the pin, and mount the cotter pin.
–
Operate the foot brake lever repeatedly until the brake linings are in contact with
the brake disc and there is a pressure point.
101384-01
–
Add brake fluid to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount screw cap
Info
Clean up overflowed or spilt brake fluid immediately with water.
101380-10
with membrane and the O-ring.
1 2
, pull out pin , and remove the brake linings.
3 4
in the brake caliper and sliding plate
5
.
A
p. 107)
with membrane and the O-ring.
1 2
73
in the brake
6