Advertisement
DISASSEMBLY ADVICE
to replace SPRING ON/OFF
SWITCH (4)
to replace BATTERY (6)
PCB (7)
remove
SCREW A
N.B. Never use again a deformed trimmer clamp (10).
Before reassembling the battery holder, make sure that the
internal wiring is guided.
After the product has been repaired, it should function properly
and has to meet the safety requirements as laid down and offi cially
established at this moment.
PCS 101 335
to replace ZOOM RING +
GUIDE PART (8)
SPRING ZOOM RING (9)
SPRING POP-UP
TRIMMER (11)
POP-UP TRIMMER (12)
remove
COMB (1)
remove
CUTTER (2)
remove
TRIMMER CLAMP (10)
± 80 mm
0.5 mm
5 mm
Prepare a disassembly tool of a metal strip.
Insert the disassembly tool into the small
gap on the rear side of the product.
1
2
Turn and push the zoom ring as shown in
the picture.
Advertisement
