How To Install And Replace Batteries In The Temperature Station - La Crosse Technology WS9245 Instruction Manual

3. After the batteries are inserted, the Temperature Station will start receiving data
signal from the transmitter. The outdoor temperature should then be displayed on
the Temperature station. If this does not happen after 2 minutes, the batteries will
need to be removed from both units and reset from step 1.
4. In order to ensure sufficient 868 MHz transmission however, this should under
good conditions be a distance no more than 80 meters between the final position of
the Temperature Station and the transmitter (see notes on "Positioning" and "868
MHz Reception").

HOW TO INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION

The Temperature Station uses 2 x AA, IEC LR6, 1.5V
batteries. When batteries will need to be replaced, the
low battery icon will appear on the LCD. To install and
replace the batteries, please follow the steps below:
1. Lift up the battery compartment cover.
2. Insert batteries observing the correct polarity (see
marking).
3. Replace compartment cover.
NOTE: During a reset or battery change, it is
recommended to leave the station and sensor without power for 10 minutes.
22