Operation; Starting Your Appliance; Sleep Mode; Turning On And Off - Electrolux ICON Use & Care Manual

Temp
Temp
Minus
On/Off
keypad
keypad keypad
on
off
alarm reset
Power Failure

Starting your appliance:

Plug the appliance power cord into a 115
volt wall outlet. Your appliance is shipped
from the factory in the "On" position and
will begin start-up of cooling as soon as
power is supplied. If the appliance does
not start, confirm that the wall outlet has
power, and that the control is in the "On"
position, (See "Turning your appliance On
and Off").
The control display is covered with a clear
plastic film. This film may be removed by
carefully lifting the film at a corner.
On initial power up, the control display will
indicate a "Power Failure" alarm. This is
a normal condition as the appliance was
powered-up at the factory for quality inspection
and then removed from power. A momentary
press of the "On/Off" keypad will reset this
alarm condition. (See Alarms section).

Sleep mode:

If no keypads are pressed for 60 seconds,
the display will enter sleep mode to
conserve power. The control panel will
go dark with the exception of the system
status "OK" indicator which will remain
enabled. Alarm conditions will wake the
display, (See Alarms section).
To make the following changes to the
control settings (turning the appliance ON/
OFF, adjusting the temperature, changing
the interior lights, and activating vacation
mode), the control must be awake.
Plus
Display Area

Electronic Control Display

on
off
alarm reset
light
light
To wake the display press any keypad. A
confirm tone will sound, and the current
storage compartment temperature will be
displayed.
light lock
The sleep mode can be disabled if you
prefer to have the display on continuously.
Press and hold the "Lock" keypad until the
display goes past "Loc" and reads "nSL".
To enable the sleep mode, repeat the
instruction, again going past "Loc" until the
display reads "SLP".
Turning your appliance ON and OFF:
If the appliance is "On", (and out of sleep
mode) the temperature will be shown in
the display area of the control. To turn the
appliance "Off", press and hold the
"On/Off" keypad for four seconds. "OFF"
will now be displayed on the control.
To turn the appliance "On", press and hold
the "On/Off" keypad for four seconds.

Operation

System
Lock Status
keypad indicators
door ajar
lock
power failure
temp
air filter
on
off
on
off
9