Electrolux ICON Use & Care Manual page 7

Floor Mount Installation
The anti-tip bracket is to be located on the
floor in the left or right rear corner of the
wine cooler.
Step by step instructions for locating
the position of the bracket:
1 Decide where you want to place the
wine cooler. Slide it into place, being
careful not to damage the floor, leaving 1"
(2.5cm) of clearance from the rear wall to
allow room for the anti-tip bracket.
2 Raise the rear leveling legs
approximately ¼" (6mm) to allow
engagement with the anti-tip bracket.
Level the unit by adjusting all the leveling
legs as required. Turning the leveling leg
counterclockwise will raise the unit and
clockwise will lower the unit.
3 Make sure the wine cooler is in the
desired location, then mark on the
floor the rear and side corner of the
cabinet where the anti-tip bracket will
be installed. If the installation does not
21 1/2"
(54.6cm)
ALL UNITS CAN TIP
Rear Leveling leg
"V" notches
in bracket
allow marking the rear corner of the
cabinet, then make temporary lines
on the floor marking the front corner
of the cabinet, excluding the drawer.
Slide the wine cooler out of the way.
From the temporary line extend the
sidewall line back 21½" (54.6cm).
4 Align the anti-tip bracket to the marks
on the floor so the side of the bracket
lines up with the side of the cabinet
mark, and the "V" notches on the anti-
tip bracket line up with the end of the
21½" (54.6cm) line (Rear of cabinet line).
5 Fasten the anti-tip bracket to the floor
using the supplied screw.
6 Slide the cabinet back into position,
making sure the rear cabinet leveling
leg slides under the anti-tip bracket
engaging the slot.
NOTE
If installing on a concrete floor, concrete
fasteners are required, (not included with
the anti-tip kit).
Anti-Tip
Leveling Leg
Bracket
21 ⁄ "
1
Bottom View of
2
(54.6cm)
Screw
TIP OVER HAZARD: One
of the rear cabinet leveling
legs must be engaged
under an anti-tip bracket.
Installation
Wine cooler
Front of
cabinet
"V" notches
in bracket
WARNING
7