Fat Shark
Transmitter
Channel select chart:
Ch1 5740 MHz
Ch2 5760 MHz
Ch3 5780 MHz
Ch4 5800 Mhz
Ch5 5820 MHz
Ch6 5840 Mhz
Ch75860 MHz
WARNING: DO NOT POWER TRANSMITTER WITHOUT ANTENNA ATTACHED. NO
ANTENNA LOAD WILL DESTROY RF AMPLIFIER – NOT COVERED BY WARRANTY
Small white connector on back of transmitter is for ImmersionRC Tiny Telemetry.
See accessories.
Camera
2.8mm lens for wide angle 100 degree FOV; ideal for fixed camera piloting.
Camera is NTSC/PAL selectable (NTSC default, remove jumper on back for PAL).
Plugs camera directly into TX via included cable (pre assembled).
Power (via discharge filter supply)
The discharge filter supply allows you to power your downlink equipment from your
onboard RC pack. Connect as shown below:
AV in/out Port
RCA Connector: Yellow: Video, White:
Audio Left, Red: Audio Right
Recording Video
Connect AV cable to AV out port on right side of headset. Connect recording
device to cables and set up as per manufacturer directions.
Note: Cables pins are not all the same (see above chart), be sure to connect to
headset using the included cable.
1
2
On
On
Off
On
On
Off
Off
Off
On
On
Off
On
On
Off
6
3
4
On
N/A
On
N/A
On
N/A
On
N/A
Off
N/A
Off
N/A
Off
N/A
Ground Video
RC Vision Systems
AudR
AuL
Need help?
Do you have a question about the PREDATOR V2 and is the answer not in the manual?
Questions and answers