Operating The Appliance; Tools And Accessories; After Use - Morphy Richards VC73184 User Manual

73184 Rev1 9/4/08
A
B
C
D
U U K K H H e e l l p p l l i i n n e e 0 0 8 8 4 4 4 4 8 8 7 7 1 1 0 0 9 9 4 4 9 9
4 4
10:42 Page 4
OPERATING THE
APPLIANCE
Using
1 Assemble the cleaner as
required.
2 While holding the cleaner, use
the plug to pull out the full
length of cable. A red mark
indicates the maximum length.
Do not try to pull the cable past
this mark.
Connect the plug to the mains
3
supply.
4 Press the ON/OFF button.
5 Check the suction control and
floor nozzle controls are set as
required.
6 Start vacuuming.
The cleaner must be
horizontal when in use. Do
not use the cleaner in an
upright position.

After use

1 Switch off the vacuum cleaner.
2 Unplug from the mains.
3 Rewind the cable by pressing
the rewind button.
WARNING: When using the
cable rewind, always hold
the plug, as the cable will
rewind quickly.
TOOLS AND
ACCESSORIES
1 Fit the hose to the cleaner by
inserting the hose end into the
hose inlet ⁄. When removing,
squeeze the clips either side
and pull.
2 Attach the telescopic tube.
Extend to the required length by
pushing up the slider release
and pulling out the tube A.
R R e e p p l l a a c c e e m m e e n n t t P P a a r r t t s s 0 0 8 8 4 4 4 4 8 8 7 7 3 3 0 0 7 7 1 1 5 5
The hose handle features a
regulator Î which allows the
suction to be reduced as
required B. Closed gives full
suction, open gives reduced
suction.
3 Attach the floor nozzle Ì to the
telescopic tube.
2-position floor
nozzle
Ì
The brushes should be retracted
for use on carpets, and
extended for use on hard floors,
by adjusting the lever on top of
the floor nozzle.
Turbo nozzle
(certain models only) Ó
This nozzle is suitable for
cleaning and rejuvenating cut
pile carpets and is ideal for
picking up stubborn dirt and pet
hairs.
Cleaning the turbo nozzle:
The turbo nozzle should be
regularly cleaned and any hairs
or fibres wrapped around the
brush bar removed to maintain
optimum performance.
Hand Tools
The crevice tool / brush (for
awkward places, behind
radiators etc.) and the
upholstery nozzle (for curtains
and upholstery) are stored inside
the cleaner under the cover C.
Slide the cover release button
· to open the cover.
The crevice tool has a
flip-action brush attachment for
hard surfaces, pelmets, delicate
objects etc.
Storage hook
A slot is provided on the base of
the cleaner to allow neat storage
of the hose and tubes after use
D.
I I r r e e l l a a n n d d H H e e l l p p l l i i n n e e 1 1 8 8 0 0 0 0 4 4 0 0 9 9 1 1 1 1 9 9