Peavey PXR 1506 Operating Manual page 8

Rear Panel
1
100-120V 220-240V
2
3
Features
VOLTAGE SELECT SWITCH
1
This switch must be set properly for the local AC line voltage. Select between 115 (110-120 VAC) or 230 (220-240 VAC)
using this switch.
POWER SWITCH
2
This switches the unit on or off. When the unit is powered ON, the front-panel blue LED will illuminate.
IEC POWER CONNECTOR
3
This is a standard IEC cable connector for use with standard voltages from AC wall outlets. Its safety ground pin is
connected to the chassis and should never be removed (or defeated in the line cord) for any reason. The IEC connector
contains an internal fuse holder. The fuse rating is 5 amperes.
SPEAKER OUTPUTS
4
These are two-conductor 1/4" speaker outputs. Each one is rated at 8 ohms minimum impedance. Total minimum load for
the amplifier is 4 ohms. You may connect either one 4-ohm, one 8-ohm or two 8-ohm speakers. Do not operate below rated
minimum impedance. For maximum power transfer, be sure to use speaker cables and not instrument cables to connect to
the speakers. We recommend the use of 18-gauge or larger speaker wire.
LINE SEND
5
This is a 1/4" two-conductor line output. It is intended to connect the mixer to the input of an external effects device or
additional power amp, or to send a submix to a larger P.A. system. This line-level signal disconnects the main outputs.
LINE RETURN
6
This is a 1/4" two-conductor line input. It is intended primarily to connect the mixer to the output of an external effects
device.
MEDIA IN (L/R)
7
These RCA jacks are for connecting a cassette deck, CD player or other line-level source.
REC OUT (L/R)
8
These RCA output jacks are primarily intended for connecting a tape deck, MP3 player, or other device for the purpose of
recording from the mixer. Both channels are summed into mono for compatibility. The signals are taken pre-master section,
meaning that they are without reverb or the master tone section, and do not include the Tape-In signal.
4
WARNING
THE ON/OFF SWITCH IN THIS APPARATUS
DOES NOT BREAK BOTH SIDES OF THE MAINS.
HAZARDOUS ENERGY MAY BE PRESENT INSIDE
THE ENCLOSURE WHEN THE POWER SWITCH IS
IN THE OFF POSITION.
7 8
6
5