Volume Control; High Control; Effects Control - Peavey PXR 1506 Operating Manual

Front Panel
1
Input Section
3-PIN LOW-IMPEDANCE MICROPHONE INPUT
1
This input is for typical balanced, low-impedance microphones. This has an input impedance of 1k ohms. The connector
is wired as: Pin 1=shield; Pin 2=positive (hot); Pin 3=negative (cold).
1/4" LINE/HIGH-IMPEDANCE INPUT
2
This input may be used as either a high-impedance microphone input or for line-level devices such as a cassette player,
CD player, video projector or laptop. This will also allow connection from an electric guitar, bass or keyboard. It is a
two-conductor input with an impedance of 10k ohms.
Features

VOLUME CONTROL

3
The level control for each channel sends the signal to the master mix bus. Typical operation is between 4 and 8 (dependent
upon the input devices) but should be lower than the master level. Please remember that this acts like a preamp, so if you
are using a device that has a volume output control (i.e.: a tape or CD player) you will need to do some level matching by
adjusting the level controls on each unit.

HIGH CONTROL

4
This is used to adjust the overall tone of the individual inputs. Since it is a cut or boost control (+/-15 dB), it will add or
diminish presence frequencies in the sound beginning at 2 kHz.
LOW CONTROL
5
This is used to adjust the overall tone of the individual inputs. Since it is a cut or boost control (+/-15 dB), it will add or diminish bass
frequencies in the sound beginning at 300 Hz.

EFFECTS CONTROL

6
This is used as a send control to the effects bus. It controls the amount of reverberation added to the input signals.
6 4 5
2 3