Dry Ironing - Morphy Richards Comfigrip 300007 Instruction Booklet

RN40737MUK Rev4.qxp_Instruction Booklet 26/03/2015 10:23 Page 5

Dry ironing

You can use your iron as a dry
iron only. Make sure the variable
steam control › is set to the '0'
symbol.
Any temperature setting may be
used depending on the
garment. The spray feature may
be used, providing there is
water in the tank (see the
'Filling' section on page 4). You
do not need to put any water in
the tank when dry ironing only.
Spray
C
Press the spray button fl and
aim the spray of water at
stubborn creases. You can do
this whilst dry ironing, providing
there is water in the tank. When
using the water spray, it may be
necessary to push the button a
few times to get the spray pump
primed.
Variable steam
Fill the iron with water (as
described in the 'Filling'
section on page 4) and
insert the plug into the
electrical socket.
The steam output can be varied
from low to high by moving the
variable steam control D. When
using the iron at 2 dot, the
steam output should be
adjusted to the low setting.
The steam facility should only
be used on garments which are
suitable for ironing at 2 and 3
dot setting.
Shot of steam
Press the steam boost
button fi to obtain a
burst of extra steam for
ironing out creases in
heavy material such as
denim etc.
The steam boost can be used
whilst dry ironing, providing
there is water in the tank, and
the temperature control is set
within the steam range.
Do not use the steam boost at
temperatures below the steam
range shown on the control dial.
NOTE: For optimum steam
quality, do not operate the
steam boost more than three
times in succession.
Vertical steam
Hold the iron in a vertical
position between 1cm and 2cm
away from the item F. Press the
steam boost button fi, this will
create vertical steam. This
feature is especially useful for
removing creases from hanging
clothes, curtains, wall hangings,
etc.
NOTE: For optimum steam
quality, do not operate the
steam boost more than three
times in succession.
No drip system
D
Your iron is fitted with a no drip
system which is designed to
prevent water escaping from the
soleplate when the iron is too
cold.
During use, the no drip system
may emit a loud click,
particularly during heat-up or
whilst cooling down. This is
perfectly normal and indicates
that the system is functioning
correctly.
Auto shut-off
(certain models only)
If your iron is fitted with the auto
shut-off function, it will
E automatically shut down after a
set period.
If the iron is left unattended in
the horizontal position, it will
shut down after 1 minute.
If it is left in the vertical position,
it will shut down after 8 minutes.
The auto shut-off light ‡ will
flash, indicating the product is in
shut-down mode.
C
F
D
Lower steam
Higher steam
E
5