Standard Accessories - Hitachi CR 18DMR Handling Instructions Manual

STANDARD ACCESSORIES

CR18DMR
CR18DL
CR18DMR
CR18DL
(NN)
(For kit)
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
1. Battery (EB1820L, EB1824L, EB1826HL, EB1830HL,
EB1830X, EB1833X, EBM1830)
2. Blades
(1) No. 1 Blade
(2) No. 2 Blade
(3) No. 3 Blade
(4) No. 4 Blade
(5) No. 5 Blade
(6) No. 8 Blade
(7) No. 9 Blade
(8) No. 95 Blade
(9) No. 96 Blade
(1) – (9) : HCS Blades (HCS : Highspeed Carbon
Steel)
(10) – (20) : Bl-METAL Blades
Refer to Table 3, 4 and 5 for use of the blades.
Optional accessories are subject to change without
notice.
1
1 Blade (No. 103) ............................................................................................................... 1
2 Hexagonal bar wrench ................................................................................................... 1
3 Charger (UC24YFA or UC18YG or UC18YRL) ........................................................... 1
4 Battery CR18DMR (2BLFK) (2HLFK), CR18DL (2MRK) .............................................. 2
CR18DMR (BLFK) (HLFK), CR18DL (MRK) .................................................... 1
5 Plastic case ....................................................................................................................... 1
1
1 Blade (No. 103) ............................................................................................................... 1
2 Hexagonal bar wrench ................................................................................................... 1
(10) No. 101 Blade
(11) No. 102 Blade
(12) No. 103 Blade
(13) No. 104 Blade
(14) No. 105 Blade
(15) No. 106 Blade
(16) No. 107 Blade
(17) No. 108 Blade
(18) No. 121 Blade
(19) No. 131 Blade
(20) No. 132 Blade
2
2
APPLICATIONS
Cutting pipe and angle steel.
Cutting various lumbers.
Cutting mild steel plates, aluminum plates, and
copper plates.
Cutting synthetic resins, such as phenol resin and
vinyl chloride.
For details refer to the section entitled "SELECTION OF
BLADES".
BATTERY REMOVAL/INSTALLATION
CAUTION
Be sure to keep the switch turned off and the lock-
off button moved to right position (lock position)
(See Fig. 18).
1. Battery removal
Hold the housing tightly and push the battery latches
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
〈 UC24YFA, UC18YRL 〉
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle
When the power cord is connected, the charger's
pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger
Insert the battery firmly, until it contacts the bottom
of the charger compartment.
3
4
5
18