Operational Parameters; Tools Recommended For Installation - Watts Premier UC-2 Installation, Operation And Maintenance Manual

Operational Parameters

Do not use with water that is microbiologically unsafe or of unknown quality, without adequate
disinfection before or after the system. Instalation needs to comply with state and local plumbing
regulations.
Operating Temperatures
Operating Pressure
pH Parameters
Flow Rate
Contents of Under Counter System
1 UC-1 Unit
2 Filters
1 Parts Bag
1 Manual and Warranty Card
If any of the items are missing, please contact Watts Premier prior to installing.

Tools Recommended For Installation

√ A small knife
√ Variable Speed drill
√ 1/8" (3mm), 1/4" (6.4 mm) and 7/16" (11.0mm) Drill bits
√ 1/2" and 5/8" open-end wrenches (or adjustable Wrenches)
√ Phillips screwdriver
This system has been designed to fit under most kitchen sinks. Please read
carefully before proceeding with installation.
Step 1:
Mounting System Under Sink
A. Locate a space under the sink that allows
the unit to be mounted close to the cold water
supply and allows for easy access when
changing filters. Allow 2" a (5cm) clearance
between the bottom of the filter housing and
the floor of the sink cabinet for filter changes.
B. Using the mounting hole on the bracket,
mark the location for the mounting screws
on a wall under the sink.
C. Screw the (2) screws into the wall at the
marked location.
D. The UC-2 bracket is designed to be
mounted without removing the (2) screws.
Hang the UC-2 module on the screws using
the mounting holes in the bracket.
Maximum
100 ºF (37.8 ºC)
100 psig (7.43 g/cm2)
8.5
0.5 GPM @ 60 psig
Installation
Two Stage Under Counter (UC-2) Two Stage Under Counter (UC-2)
3
Minimum
40 ºF (4.4 ºC)
20 psig (1.406kg/cm2)
6
Sink Sink
Green Tubing Green Tubing
COLD COLD
HOT HOT
Counter Top Counter Top
Blue Tubing Blue Tubing