Water Heater Operation; Gas Operation; 230V Operation; Space Heater Operation - elddis Crusader Owner's Handbook Manual

HOW TO USE YOUR CARAVAN'S EQUIPMENT

WATER HEATER OPERATION

Gas operation

Ultrastore Control
(i) Ensure that the water heater has been filled
with water and that the outside flue cover
has been removed.
(ii) Using the Ultrastore control knob, turn the
dial to the desired temperature setting then
turn the outer ring to the flame position.
(iii) Once the Ultrastore is switched on a green
light is visible within the switch and the unit
will now try and ignite.
(iv) If within approximately 10 seconds, the
Ultrastore fails to ignite then a red failure
light will also appear. If this happens wait 30
seconds before trying again.

230V Operation

(i) Simply depress the Electrical switch fitted
next to the gas control to the 230V position.
This will turn on the water heaters electrical
element. It is imperative that there is water
in the heater whenever the Gas or Electric is
switched on.

SPACE HEATER OPERATION

Gas Operation
Gas Control
(i) Turn the gas control on top of the heater to
the desired setting and depress the knob.
(ii) Keeping the control knob depressed look
into the viewing window and see if the gas
ignites. You should be able to hear it ticking
until the pilot light ignites.
(iii) Once the pilot light is lit keep the control
knob depressed for a further 20 seconds to
allow the thermocouple to operate.
(iv) If the heater fails to ignite please wait 20
seconds before trying again.
230V Operation
Ultraheat Control
(i) Simply depress the main switch on the
Ultraheat control panel to the 230V position.
(ii) Then set the power rating you require on
the panel at either 500w 1000w or 2000w.
9-12