Welder/Generator Maintenance; Storage; Cleaning; Brush Removal And Replacement - Lincoln Electric RED-D-ARC GX 300 Operator's Manual

D-5

Welder/Generator Maintenance

STORAGE: Store the GX 300 in clean, dry protected
areas.
CLEANING: Blow out the generator and controls peri-
odically with low pressure air. Do this at least once a
week in particularly dirty areas.
BRUSH REMOVAL AND REPLACEMENT: It's nor-
mal for the brushes and slip rings to wear and darken
slightly. Inspect the brushes when a generator over-
haul is necessary.
CAUTION
Do not attempt to polish slip rings while the
engine is running.
WARNING
Service and Repair should only be performed by
Lincoln Electric Factory Trained Personnel.
Unauthorized repairs performed on this equip-
ment may result in danger to the technician and
machine operator and will invalidate your factory
warranty. For your safety and to avoid Electrical
Shock, please observe all safety notes and pre-
cautions.
MAINTENANCE
GX 300
D-5