Parts Name Of Remote Controller - Toshiba MMD-AP0481HFE Owner's Manual

PARTS NAME OF REMOTE CONTROLLER

This remote controller can singly operate maximum 8 indoor units. However one remote controller cannot
operate the fresh air intake type air conditioner together with the indoor units for air conditioner.
If the operation contents have been set up once, the air conditioner can be operated according to the setup
contents by pushing only ON/OFF button.
The two fresh air intake units at the maximum can be connected to one refrigerating cycle.
Display section
All display items are shown in right figure for the explanation.
Only selected contents are displayed in actual operation.
• When turning on the leakage breaker at the first time, [SET DATA]
flashes on the display part of the remote controller.
While this display is flashing, the model is being automatically
confirmed. Accordingly, wait for a while after [SET DATA] display
has disappeared, and then use the remote controller.
2
1
3
4
5
6
7
15
1
SET DATA display
Displayed during setup a timer.
2
Operation mode display (HEAT, COOL, FAN)
The selected operation mode is displayed.
3
CHECK display
Displayed while the protective device works or a
trouble occurs.
4
Timer time display
Set time by the timer is displayed.
(When a trouble occurs, the check code is dis-
played.)
5
Timer SETIN setup display
When pushing the Timer SET button, the display
of the timer is selected in order of [OFF]
[OFF] repeat OFF timer
No display.
6
Filter display
If "FILTER " is displayed, clean the air filter.
7
UP/DOWN grille display (
8
Ventilator operation display
9
Louver position display (
16 9
SET DATA
SETTING TEST
UNIT No.
R.C.
H
→
→ [ON] →
∗
)
∗
)
4
SET DATA SETTING
H
TEMP.
FILTER
RESET TEST
CODE No.
No.
10
SWING display (
11
Set up temperature display
The selected setup supply air temp. is displayed.
12
Remote controller sensor display (
13
PRE-HEAT display
Displayed when the heating operation starts or
defrosts operation is carried out.
While this indication is displayed, the indoor fan
stops.
14
No function display
Displayed if there is no function even if the
button is pushed.
15
Fan mode display
The air conditioner with the fresh air intake unit
displays (HIGH)
16
TEST run display
Displayed during a test run.
∗
This function is not provided to an air conditioner
with fresh air intake unit.
CODE No.
TEST
Display
UNIT No.
section
R.C. No.
ON / OFF
TIMER SET FAN MODE
Operation
section
TIME SWING/FIX VENT
SET CL UNIT
10
11
8
12
13
14
∗
)
∗
)
only.