Advertisement
Roadside Companion Setup and Initial Test Call (continued)
Installing with Sticky
Pad
™
1
3 4 5
Place the Sticky
Pad on the dash.
™
Set Up and Test Call
1
20 Degree
Angle
For best results, do not tilt the antenna more
than 20˚ from vertical.
3
4
If you have any questions, please call us at 1-888-905-6900.
2
3 4 5
Place Roadside Companion unit in the
center of the Sticky
Pad.
™
2
TEST
CALL
Plug the cigarette lighter adapter into your
Roadside Companion unit and then into your
cigarette lighter in your car. (Note: unit
requires a live power source to operate.)
The unit will beep as soon as it is plugged into
your car. At this time, the unit is receiving your
current location. The "IN USE" light will flash
once every 4 seconds indicating the Roadside
Companion unit is operational.
Roadside Companion Setup and Initial Test Call (continued)
4
5
Your Roadside Companion professional will ask if you have an emergency. Since this is
6
only your test call, please indicate to your Roadside Companion professional
that you do not have an emergency, but are making your first-time setup call.
Your Roadside Companion professional will determine your location and confirm this with you.
7
At the conclusion of your setup and test call, your Roadside Companion professional
will end the call.
If you have any questions, please call us at 1-888-905-6900.
Press and hold down the big red button until the
unit beeps, and then release the button. The red
"IN USE" light will flash on and off once every
second, indicating that the Roadside Companion
unit is searching for a signal. When the "IN USE"
light turns solid red, this indicates the call is
going through.
Listen for a Roadside Companion
professional who will greet you by name.
5
Advertisement
