Hardware Connection - Computer; Hardware Connection - Internet - TP-Link TL-PA4020P User Manual

2.3 Hardware Connection – Computer
For those computers you wish to be networked by Powerline Adapter, each of the computers must be
properly connected with a Powerline Adapter through an Ethernet (RJ45) cable.
Following are the steps to properly connect the Powerline Adapter to your computer:
1． Connect one end of the provided Ethernet (RJ45) cable to the Powerline Adapter's Ethernet port.
2． Connect the other end of the Ethernet (RJ45) cable to your computer's LAN port.
3． Plug the Powerline Adapter into a wall socket.
4． Turn on your computer.
5． Check and confirm that the Power LED
ON.
The hardware connection mechanism is shown below:

Note:
Do not connect the Powerline adapter to any extension lead, power strip, extension cord or surge
protector, as these may degrade the network performance.
2.4 Hardware Connection – Internet
This section describes how to connect the Powerline Adapter into your existing ADSL broadband
connection via ADSL Ethernet port. Follow the procedures described below to connect the Powerline
Adapter to your ADSL broadband connection:
1． Connect one end of the provided Ethernet (RJ45) cable to the Powerline Adapter's Ethernet port.
2． Connect the other end of the Ethernet (RJ45) cable to an available Ethernet port of your ADSL
broadband Router.
3． Plug the Powerline Adapter into a wall socket.
4． Check and confirm that the Power LED
Powerline Adapter are ON.

Note:
If any LED does not turn on, refer to
TL-PA4020P AV600 2-port Passthrough Powerline Adapter
and Ethernet LED
s
b p
0 M
6 0
, Ethernet LED
Appendix: Troubleshooting.
6
on the Powerline Adapter are
, and Powerline LED on the