Leave An Existing Secured Powerline Network; Reset - TP-Link TL-PA4020P User Manual

Step 1. Press and hold the Pair button on Powerline adapter C for one second.
Step 2. Within 2 minutes,
Step 3. Wait until the Power LED on both adapters stops flashing and the Powerline LED becomes
solid on, and the pairing is completed.

Note:
The sequence of Step 1 and Step 2 can be exchanged.

3.2 Leave an existing secured powerline network

As the figure above shown, Powerline adapter A, B and C have formed a HomeplugAV Network. The
user wants to remove one device (Powerline adapter A) from this network.
Step 1. Press and hold the Pair button on powerline adapter A for about 8 seconds, and then release
the button. (All LEDs of powerline adapter A will momentarily go off.)
Step 2. Wait until the Powerline LED of powerline adapter A turns off, and the powerline adapter is
disconnected from the powerline network.

3.3 Reset

To reset the powerline adapter：
Press and hold the Pair button for at least 15 seconds, and then release the button. You will see all LEDs
go off momentarily, and then begin to flash. When the Power LED turn solid, the reset process is
completed.
Be careful, don't power off the powerline adapter when it is in reset process.
TL-PA4020P
ress and hold the Pair button on Powerline adapter A/B for one second.
p
AV600 2-port Passthrough Powerline Adapter
9