Panasonic SC-PM46 Operating Instructions Manual page 13

Compatible devices Compatible devices
Devices which are defi ned as USB mass storage class:
• USB devices that support bulk only transfer.
• USB devices that support USB 2.0 full speed.
Supported Format Supported Format
Files must have the extension ".mp3" or ".MP3".
Note
• CBI (Control/Bulk/Interrupt) is not supported.
• A device using NTFS fi le system is not supported [Only FAT
12/16/32 (File Allocation Table 12/16/32) fi le system is supported].
• Depending on the sector size, some fi les may not work.
• This unit can access up to 255 albums (including blank folders) and
2500 tracks.
• The maximum number of tracks in a folder are 999 tracks.
• Only one memory card will be selected when connecting a multiport
USB card reader. Typically the fi rst memory card inserted.
• Do not unplug the USB device during reading or playback.
• Disconnect the USB card reader from the unit when you remove
the memory card. Failure to do so may cause malfunction to the
device.
• When you connect a compatible digital audio player to the USB
port, charging may be activated. It will not charge when the unit is
switch to standby mode or during tape recording.
Connecting and playing a Connecting and playing a
portable audio equipment portable audio equipment
This feature enables you to enjoy music from portable audio
equipment.
Audio cord (not included)
Portable audio equipment
(not included)
Switch off the equalizer function (if there is any) of the portable audio
equipment before you plug into the MUSIC PORT jack. Otherwise,
sound from the speaker may be distorted.
1 Plug the audio cord into the MUSIC PORT jack and press
[MUSIC PORT].
Play the portable audio equipment. (See the portable audio
2
equipment's instruction manual.)
Note
All peripheral components and cables are sold separately.
Changing the remote control code Changing the remote control code
Change the code if you fi nd the remote control unintentionally also
controls other equipments.
Change the main unit's code Change the main unit's code
Press and hold [MUSIC PORT] on the main unit and then press
and hold [2] (or [1]) on the remote control.
"REMOTE 2" is displayed.
Change the remote control's code Change the remote control's code
Press and hold [ENTER] and [2] (or [1]) on the remote control for
at least 2 seconds.
If the remote control and main unit are using different codes, a
message appears on the main unit's display showing the main unit's
current code. Follow the above step to change the remote control's
code to match it.
13