Calling; Redial Previous Numbers; If The Number Is Busy; End Call - Siemens M55 User Manual

Dialling with number
keys
The phone must be switched on
(standby mode).
J
Dial number (always with
area code, if necessary
with international dialling
code).
§Clear§
the last digit, a long press
clears the entire phone
number.
A
Press the Call key to dial
the number.

End call

B
Press End key briefly.
The call is ended. Press this key even
if the person on the other end of the
line has hung up first.

Set volume

E
Use the control key (top)
to start adjusting the vol-
ume (only possible during
conversation).
G
Set volume and confirm
with §OK§.
If a Car Kit is used, its volume setting
will not affect the usual setting on
the phone.
A short press clears

Calling

Redial previous numbers

To redial numbers that were dialled
previously:
A
G
A

If the number is busy

Auto. redial
§Auto dial§
Or
Call back
§Call back§
Reminder
§Prompt§
International dialling code
In standby mode, to insert international di-
alling codes from the list:
0
§+List§
Press the Call key once.
Pick out the required
phone number from the
list, then press ...
... to dial.
The phone number is au-
tomatically dialled ten
times at increasing time
intervals.
Your phone rings
when the engaged
number is free.
A beep reminds you to re-
dial the displayed phone
number after 15 minutes.
Hold down until a "+" is dis-
played. This replaces the first
two digits of the international
dialling code.
Press and select country.
15
L