Advertisement
7
Tighten both yoke set screws to fur-
ther secure downrod.
10
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
13
Raise the canopy up and align the
two holes in the canopy with the two
holes in the hanger bracket. Secure
with two screws provided.
16
Loosen 2 screws with key slots and
remove 1 screw without slot from
motor plate and save screw.
8
Carefully lift fan assembly onto mounting
bracket. Rotate fan so that the notch on the
ball engages the ridge in the mounting bracket.
This will allow hands-free wiring.
House
11
Black
White
Green
For pullchain controls, follow diagram above.
Make sure that all exposed wiring is secured
inside wire nuts. Note: Wires from house may
vary in color and may not include ground wire.
After wiring is conplete, gently push wires into
junction box with wire nuts pointing upward.
Refer to point 3 of safety tips.
14
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades
17
Install switch housing plate by twist-
ing plate with key hole slots into
place. Replace screw removed and
tighten the 3 screws securely.
9
Safety Cable
Lag Screw
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3" lag screws provided. Make sure that
when the safety cable is fully extended the
leadwires are longer than the cable and no
stress is placed on the leadwires.
Fan
12
Black
Blue
White
Green(downrod)
Green(Bracket)
For control of fan and optional light from wall
location, follow diagram above. NOTE: A profes-
sional electrician is recommended for this type
of installation.
15
Check the motor for plastic shipping stabilizer
tabs, and remove them if they are present. The
screws, washers, and motor pads are pre-
installed to the blade holders. Attach blade
assembly to motor and tighten screws securely.
18
Connect plug from fan to switch
house plug.
Safety cable installation
Wall
Control
Advertisement
