Installation - Westinghouse WLE522WA User Manual

INSTALLATION

Location
The appliance has been designed to fit a 550mm gap in
kitchen cabinetry or have free space on either side� Ensure the
top of the hotplate is at least 10mm higher than the level of the
benchtop�
Electric hob models must not be installed in a corner; they
must be installed at least 100mm from the side wall�
Gas hob models must be installed with a minimum clearance
of 100mm to side walls made of unprotected combustible
material� For gas models, refer to section 6�10�1 in AS/NZS
5601�1 for all relevant clearance�
Clearance to
side wall
(refer notes
above)
600mm min�
to combustible
material
540mm
910mm
WARNING
WARNING
In order to avoid accidental tipping of the appliance (for
example, by a child climbing onto the open oven door),
the anti-tilt plate and stabilising bolt MUST be installed�
20
INSTALLATION
550mm
min�
1150mm
Anti-tilt plate
1 �25m electrical
service cord (if fitted)
620mm
Rear cover
25mm to
side of
bracket
5mm clearance
Cooker width Anti-tilt
540mm plate
Rear adjustable foot
Position anti-tilt plate to the rear wall and 25mm from side of
cupboard� Securely fix anti-tilt plate to the floor with fasteners�
Adjust levelling feet on cooker as required�
Stabilising bolt
Stability
bolt
Kick-panel
1� Remove oven door - to be done by qualified personnel only�
(Refer to procedure)�
2� Remove screws from kick panel� To remove kick panel lift
kick panel upwards to release the two location tabs from
the holes in the bottom of the panel�
3� Position cooker into the ant-tilt plate and then mark the
position for the stability bolt hole on the floor�
4� Pull cooker out and drill the bolt hole, using a 6�5mm
masonry or wood drill bit� The bolt hole needs to be a
minimum
of 30mm deep when fixing the oven to concrete�
5� Reposition cooker back into place and fit the stability
bolt through the slot and into the drilled hole�
6� If the cooker is placed on a base, measures must be
taken to prevent the appliance slipping from the base�
7� Carefully remove any protective plastic film to prevent
damage to the appliance�
WARNING
WARNING
For your safety this cooker is designed to be moved out of
position by a qualified person only�
Front
adjustable
6�5mm
feet
ø drilled
location hole