Adjusting Thoracic Height On Width Adjustable Lateral Supports; Fastening Support Straps - Quest 88 Trikes User Manual

Adjusting Thoracic height
on Width Adjustable Lateral
Supports
The height of the thoracic support should be set up as described
earlier, with a three finger gap between the user's armpit and the
top edge of the thoracic support.
To adjust the height of the thoracic support with width adjustable
laterals, use the dumbell spanner in the tool kit to undo the two bolts
on the ends of the painted section of the thoracic control assembly.
With these bolts undone, slide the thoracic support up or down to
the desired height. Once in place, tighten up the bolts and ensure
they are firmly tightened before use.

Fastening Support Straps

The straps must fit the user snuggly. Loosely fitting the straps should
be avoided as the user may come out of position on the saddle and
become trapped by the straps. Fit the free end of the strap through
the buckle on the other end and pull until the user is held firmly but
their breathing is not restricted. Fasten the buckle by pushing the
lever into the body of the buckle. To undo, tug the free end of the
strap forwards so that it pulls the buckle open.
tel: +44 (0)1952 463050
Quest 88 limited, Aston Street, Shifnal, Shropshire, TF11 8DW
fax: +44 (0)1952 463077 www.quest88.com email:general@quest88.com
QD. TRINST1.P65 iss.7/GJ-06/09
9