Fitting Guide; Notes On Fitting Wheel Discs - Quest 88 Trikes User Manual

QD. TRINST1supp.PM6 iss.7/GJ-06/09
16

Fitting guide -

for printed wheel covers
Feed wheel cover (at slot) behind the mudguard stay and over hub.
Align holes in covers either side of the wheel. (3 holes Kitten wheel
covers, 5 holes Colt/Carousel, 5 holes Panther).
Insert longer (female) plastic fastening through holes in each disc
and secure using smaller (male) fastening

Notes on fitting wheel discs

Finger tighten, do not over tighten, if using a screwdriver as this
may split the fastenings.
Repeat for each set of holes.
Carefully tuck the exposed edge at the split disc, behind the secured
edge. Black (unprinted) discs are to be used on the inside of the
rear wheels.
You will need to remove the discs as appropriate for access to the
valve for inflating tyres (Kitten Trike). The rear Colt and Carousel wheel
covers have cutouts for access on rear wheels. When retrofitting wheel
covers to the Colt, Carousel and Panther tricycles, you will need to
remove any reflectors from the wheels.
tel: +44 (0)1952 463050
Quest 88 limited, Aston Street, Shifnal, Shropshire, TF11 8DW
fax: +44 (0)1952 463077 www.quest88.com email:general@quest88.com
1
2
3
4
5