Locking And Unlocking; Vehicle Key; Changing The Battery In The Remote Control Key - Skoda 2011 Yeti Owner's Manual

Locking and Unlocking

Vehicle key

Fig. 22 Set of keys without remote control/Keys with remote control key
Two keys are provided with the vehicle. Depending on the equipment, your vehicle
can be equipped with keys without radio remote control
 fig. 22
remote control - right.
WARNING

Always withdraw the key whenever you leave the vehicle - even if it is only
for a short time. This is particularly important if children are left in the vehicle.
The children might otherwise start the engine or operate electrical equipment
(e.g. power windows) - risk of injury!

Do not withdraw the ignition key from the ignition lock until the vehicle has
come to a stop. The steering lock might otherwise engage unintentionally - risk
of accident!
Caution

Each key contains electronic components; therefore protect them against mois-
ture and severe shocks.

Keep the groove of the keys absolutely clean as impurities (textile fibres, dust
etc.) have a negative effect on the proper operation of the locking cylinder and the
ignition lock.
Using the system Safety
Please approach an authorised Škoda Service Partner if you lose a key since he can
obtain a new one for you.

Changing the battery in the remote control key

 fig. 22
- left, or with radio
Fig. 23 Remote control key - remove cover/remove battery
Each remote control key contains a battery which is housed under the cover
 fig.
you press a button on the remote control key
have the batteries of the key replaced by an authorised Škoda Service Partner. You
should, however, proceed as follows if you wish to replace the discharged battery
yourself:
–
–
–
–
–
Driving Tips General Maintenance
Note
23. If the battery is discharged, the red warning light
Fold open the key.
Press off the battery cover with your thumb or using a flat screwdriver at the
points of the arrows A from  fig.
1
Remove the discharged battery from the key by pressing the battery down-
 fig.
wards at the point of the arrow A
2
Insert the new battery. Ensure that the "+" symbol on the battery is facing
upwards. The correct polarity is shown on the battery cover.
Position the battery cover on the key and press on it until it is heard to lock in
place.
Breakdown assistance
Locking and Unlocking
A
does not flash after
A
 fig. 22. We recommend that you
23.
23.
Technical data
35
A
B