Skoda 2011 Yeti Owner's Manual page 115

114 Starting-off and Driving
Switching the "START-STOP" system on and off
You can switch the "START STOP" system on/off by pressing the button
fig. 118.
When start-stop mode is deactivated, the warning light in the button lights up.
If the vehicle is in the stop phase when manually switching off the system, the
engine starts immediately.
The "START-STOP" system is very complex. Some of the procedures are hard to
check without servicing. The general conditions for the proper functioning of the
"START-STOP" system are listed in the following overview.
Conditions for the automatic engine shut down (stop phase)
The gearshift lever is in Neutral.
The clutch pedal is not pressed!
The driver has fastened the seat belt.
The driver's door is closed.
The bonnet is closed.
The vehicle is at a standstill.
The factory-fitted towing device is not electrically connected to a trailer.
The engine has reached its operating temperature.
The charge state of the vehicle battery is sufficient.
The stationary vehicle is not on a steep slope or a steep downhill section.
The engine speed is less than 1200 1/min.
The temperature of the vehicle battery is not too low or too high.
The pressure in the brake system is sufficient.
The difference between the outdoor- and the set temperature in the interior is
not too great.
The vehicle speed since the last time the engine was switched off was greater
than 3 km/h.
No cleaning of the diesel particle filter takes place page 28
The front wheels are not turned excessively (the steering angle is less than 3/4 of
a steering wheel revolution).
Conditions for an automatic restart (start phase)
 page 113,
The clutch is pressed.
The max./min. temperature is set.
The Defrost function for the windscreen is switched on.
A high blower stage has been selected.
The "START STOP" button is pressed.
Conditions for an automatic restart without driver intervention
The vehicle moves at a speed of more than 3 km/h.
The difference between the outdoor- and the set temperature in the interior is
too great.
The charge state of the vehicle battery is not sufficient.
The pressure in the brake system is not sufficient.
Messages in the instrument cluster display (valid for vehicles without Information
display)
ERROR: START STOP
START STOP NOT POSSIBLE
START STOP ACTIVE
SWITCH OFF IGNITION
START MANUALLY
WARNING

The brake servo unit and power steering only operate if the engine is
running.

Never let the vehicle roll with the engine switched off.
Error in the START-STOP system
Automatic engine shut down is not pos-
sible
Automatic engine shut down (stop
phase)
Switch off the ignition
Start the engine manually