Table of Contents
Advertisement
(4) Replacement of the Final Gear [20] <20> and the Ball Bearing 6201DDCMPS2L [5] <5>
1. Remove the Gear Cover Ass'y [8] <8> from the Inner Cover [12] <12> then remove the Second Pinion and
Gear Set [10] <10> and the Washer [11] <11>.
2. Fix the Gear Cover Ass'y [8] <8> to the vise and remove the Bearing Cap [3] <3> with the J-21 Wrench or a
flat-blade screwdriver and a hammer. At this time, be careful that the Bearing Cap [3] <3> has a left-hand
thread.
3. As shown in Fig. 12, support the end surface of the Gear Cover Ass'y [8] <8> with an appropriate cylindrical jig
(with about 35 mm inside dia.). Push the end surface of Spindle (A) [4] <4> with a hand press to remove the
Final Gear [20] <20>.
4. Remove the Retaining Ring for D12 Shaft [6] <6> from Spindle (A) [4] <4>.
5. Remove the Ball Bearing 6201DDCMPS2L [5] <5> from Spindle (A) [4] <4> using the J-30 Bearing Puller
(Code No. 970804).
8-2. Wiring Diagram
Wiring diagram
Model SP 18VB
35 mm inside dia.
Connector 50092 [39]
Controller [30]
Terminal [38]
Push
Fig. 12
Connector 50092 [39]
Cord [47]
Noise suppressor [43]
Switch (A) [40]
Fig. 13
--- 10 ---
Advertisement
Table of Contents
