Sony HCD-LV80 Service Manual page 2

Tuner section
FM Stereo, FM/AM superheterodyne tuner
FM tuner section
Tuning range
Antenna:
Antenna terminals
Intermediate frequency
AM tuner section
Tuning range
Middle Eastern models:
Other models:
Antenna
Intermediate frequency
General
Power Requirements
Power Consumption
Dimensions(w/h/d)
Mass
Supplied Accessories
Design and specifications are subject to change
without notice.
2
87.5 - 108.0 MHz (50 kHz
step)
FM Wire antenna
75 ohm unbalanced
10.7 MHz
531 - 1,602 kHz (with the
tuning interval set at
9 kHz)
531 - 1,602 kHz (with the
tuning interval set at
9 kHz)
530 - 1,701 kHz (with the
tuning interval set at
10 kHz)
AM loop antenna,
External antenna
terminals
450 kHz
120 V, 220 V, or 230 - 240
V AC, 50/60 Hz
Adjustable with voltage
selector
300 watts
Approx. 356 × 423 × 446
incl. projecting parts and
controls
Approx. 15.9 kg
AM loop antenna (1)
FM wire antenna (1)
Speaker cords (2)
Remote (1)
R6(size AA) batteries (2)
Video connecting cable
(1)
CAUTION
Use of controls or adjustments or performance of procedures
other than those specified herein may result in hazardous ra-
diation exposure.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Flexible Circuit Board Repairing
• Keep the temperature of soldering iron around 270˚C
during repairing.
• Do not touch the soldering iron on the same conductor of the
circuit board (within 3 times).
• Be careful not to apply force on the conductor when soldering
or unsoldering.
Laser component in this product is capable of emitting radiation
exceeding the limit for Class 1.
SAFETY-RELATED COMPONENT WARNING !!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE
WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN
THE PARTS LIST ARE CRITICAL TO SAFE OPERATION.
REPLACE THESE COMPONENTS WITH SONY PARTS
WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS
MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.
This appliance is classified as
a CLASS 1 LASER product.
The CLASS 1 LASER PROD-
UCT MARKING is located on
the rear exterior.
This caution
label is located
inside the unit.