Table of Contents
Advertisement
I
nstallation
Normal Tap without thread & screw type inlet hose
1.
Unscrew the fixing screw to
attach the tap.
Upper
Connector
Fixing screw
Normal Tap without thread & one touch type inlet hose
1.
Un tighten the upper connector
screw.
Upper
Rubber
Connector
packing
Fixing screw
Middle
connector
• In case the diameter of the tap is
large remove the guide plate.
Guide Plate
Used the horizontal tap
Horizontal tap
Extension tap
Square tap
2.
Push the connector up till the
rubber packing is in tight contact
with the tap. Then tighten the 4
screws.
Rubber
packing
Rubber packing
Upper Connector
2.
Push the upper connector up till
the rubber packing is in tight
contact with the tap. Then
tighten the 4 screws.
Rubber packing
Upper Connector
Middle
connector
• Turn the middle connector not
to have water leaked.
• Make sure that the rubber seal
Connector
is inside the hose connector.
Hose connector
3.
Push the water supply hose
vertically upwards so that the
rubber packing within in the
hose can adhere completely to
the tap and then tighten it by
screwing it to the right.
Water supply hose
3.
Connect the water supply hose
to the middle connector,
pushing the plate down.
Connector
Water supply
hose
• To separate the water supply
hose from the middle connector
shut off the tap. Then pull the
inlet hose down, pushing the
plate down.
Rubber seal
• Your machine comes with only
cold water connection.
• Make sure that there are no
kinks in the hose and that it is
not crushed.
Upper
Connector
Plate
Upper
Plate
9
Advertisement
Table of Contents
